Published On: September 26ᵗʰ, 2019 07:52

Cisco Enterprise Network Compute System Switch Command Reference

port-channel load-balance

To configure load balancing for port channels, use the port-channel load-balance command in switch configuration mode. To restore the default configuration, use the no form of this command.

port-channel load-balance { src-dst-mac | src-dst-mac-ip}

no port-channel load-balance

Syntax Description

src-dst-mac

Enables load balancing based on the source and destination MAC addresses.

src-dst-mac-ip

Enables load balancing based on the source and destination MAC and IP addresses.

Command Default

None

Command Modes

Switch configuration (config-switch)

Command History

Release Modification
3.6.1

This command was introduced.

Examples

The following example enables load balancing based on the source and destination MAC addresses:

nfvis(config-switch)# port-channel load-balance src-dst-mac
nfvis(config-switch)# commit
nfvis(config-switch)# end